Splashbacks and upstands in Hanger Hill

Yes. Hanger Hill is on the patch, and the postcodes we work here are W5. It is worked on our west London run, along with the rest of Ealing. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These houses usually sit in their own grounds with a long approach, so the carry from van to door is longer than anything inside the building. Behind a range cooker with gas burners, granite or sintered stone is the sensible pick; quartz has a resin binder and does not enjoy sustained radiant heat at close range, so keep it out of the immediate hob zone or specify a different material for that panel. Cut from the same slab run as the tops. Those walk-up blocks have tight stair turns with a low soffit, so anything over 2.4m has to be jointed simply to get it up to the flat.

The Hanger Lane gyratory and the A40 dominate the approach. The garden estate has communal courts, controlled parking and low-rise blocks with no lifts. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. Where the route is tight we break a long splashback at a natural vertical joint instead of forcing one panel through. It decides panel size before anything is cut.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Sockets final before template. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Corners get their own pieces. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. The range and extractor must be sited and the window cill finished before the template, as both fix the vertical limits of the splashback. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. Full-height panels need the wall made good first, which is another trade and another timescale. Decided before fabrication, not after.