Splashbacks and upstands in Perivale

Yes. Perivale is on the patch, and the postcodes we work here are UB6. It is worked on our west London run, along with the rest of Ealing. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Steel columns and downstands land where the frame put them, which is frequently in the middle of what would otherwise be a clean run. Setting the panel proud on a subframe with a shadow gap reads as a detail; scribing to raw brick rarely does. Cut from the same slab run as the tops. The Deco conversions have deep window reveals and non-standard ceiling heights, so set the splashback height off the actual reveal rather than the architect's drawing.

Western Avenue runs straight through with limited turnings, so overshooting means a long loop. Residential streets have drives, but the converted-factory apartments need lift booking and residents' permits. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. Joint positions follow from that.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Sockets final before template. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Siliconed to the worktop, never grouted.

Peninsulas frequently land on a lightweight partition or on units that were never fixed down, and stone needs proper support under it before it goes on. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. The joint to the worktop is siliconed, never grouted. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. An upstand rides what a panel exposes. Decide and build the backing method, scribe, subframe or board, before the template, because the templater is measuring to that face and not to the brick. A let property is specified for durability and for a fixed window, and both of those are legitimate reasons to choose differently. Splashbacks are cut from the same slab run as the tops, so they have to be decided before fabrication, not after. The wall has to be ready.