Worktop templating in Harefield

Yes. Harefield is on the patch, and the postcodes we work here are UB9. It is run from the High Wycombe side, covering Buckinghamshire & Berkshire. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A range or an Aga in an original recess is usually immovable, so the run is designed around it and the clearances come from the appliance. One datum for the whole room, because a floor that falls end to end shows as a step between island and perimeter. Two to three hours, once the units are in. Plenty of these properties run oil, LPG or solid-fuel ranges, so the aperture and heat clearances differ from a standard cooker on almost every job.

Country lanes with no pavements, single-track sections and passing places. Parking is never the issue, lane width and getting a long-wheelbase van turned round is. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop design & quotation and worktop fabrication. Where an annexe has been built or converted, its floor and its walls are newer than the main house and behave differently under the same run. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first. Where an annexe has been built or converted, its floor and its walls are newer than the main house and behave differently under the same run. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The template records every angle in that shape as it actually is rather than as the plan drew it. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. It is recorded on the drawing with the run dimensions so the workshop is not guessing. That is why the visit takes two or three hours. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. Fitted, fixed and level, then we come.