Worktop templating in Kensal Town

Yes. Kensal Town is on the patch, and the postcodes we work here are W10. It is run from the Watford side, covering Hertfordshire & North London. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Wider halls make the carry noticeably easier, and that alone can remove a join that a narrower terrace would have forced into the run. The laser plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. No stone is ever cut from a plan. Where the only route in is a footpath from the road, work out the carrying distance before quoting - it is frequently 80m-plus with a kerb and a ramp.

The canal and railway limit through-routes, so several blocks are reached from one side only and the last stretch is a footpath. Estate entrances are fob-controlled with narrow lobby doors and a lift that is often the only one for the whole block. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the laser plots the intermediate points. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. That is why the visit takes two or three hours. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.