Worktop fabrication in Kentish Town

Yes. Kentish Town is on the patch, and the postcodes we work here are NW5. It is worked on our central and north London run, along with the rest of Camden. A controlled parking zone means either a visitor permit sorted in advance or a suspended bay, and a suspension is applied for days ahead rather than on the morning. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The back addition is a narrow two-storey outrigger with a single external wall, and the kitchen galley runs the length of it. The galley run down a side-return usually measures longer than a slab will give us, so a join is designed in from the start and nested to land over a cabinet gable rather than wherever the material happens to run out. Settled on the drawing, cut once. Rear-addition walls here are routinely out by 15-25mm over 3m, so template on site and scribe rather than trusting a plan, and allow for a join where old brick meets new blockwork on a fresh extension.

Camden CPZ Monday to Saturday with very fast bay turnover, and the side roads off Kentish Town Road are one-way with build-outs, so the van usually stops on the main road and the slab is walked in. Front doors sit up three to five steps behind railings and the halls are typically under 900mm, which is the real limiting dimension rather than the doorway. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. So the nesting is worked to the measured route first and to the slab second. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us.

Side-return kitchens are long and narrow with one outside wall, and the wall the run sits against is often the oldest, least straight surface in the house. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.