Worktop fabrication in Dartmouth Park

Yes. Dartmouth Park is on the patch, and the postcodes we work here are NW5. It is worked on our central and north London run, along with the rest of Camden. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Where the side return has been filled in, the old external wall is now an internal one and still carries its render, its gutter line and its old fixings. The other constraint is the hall: a piece has to come through the front door, round the newel at the foot of the stairs and through a doorway into the back kitchen, so we size the pieces to the tightest turn on that route before we nest anything, which sometimes means splitting a run that would otherwise have gone in whole. Settled on the drawing, cut once. The island is usually the biggest single piece of the job, so book the extra pair of hands and check the extension floor is level first, because new screed over old joist lines rarely is.

Steep tree-lined streets with permit bays both sides and no room to double park, and the gradient matters when you are walking a slab on an A-frame. Front doors are up a short flight with a long straight hall to the rear, so it is the kerb-to-door step that catches people out rather than the internal run. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop design & quotation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. Changing an appliance after the nest is set means recutting the piece, not adjusting it. Dry-assembled before it leaves.