Worktop design and quotation in Lessness Heath

Yes. Lessness Heath is on the patch, and the postcodes we work here are DA17. It is worked on our south east London run, along with the rest of Bexley. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. It sits in the fitting line as time on site rather than as anything to do with the stone. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A side alley and a back door mean most pieces go in whole, and it is the alley width rather than the front door that decides it. Slab yield rather than floor area is what moves the material line, and the return piece is usually the reason. Priced from the building, not from a rate card. Standard interwar layouts, but a lot of the rear walls are single-skin later additions, check what you're fixing an upstand to.

Wide suburban roads with verges and drives, easy turning and no permit schemes; the slope down toward Erith is the only awkward stretch. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. That is why the fitting line on a quote reflects manpower and time rather than square metres. Nothing about it gets estimated after the fact.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Itemised, so it can be compared honestly. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Nothing payable until we template.

Where the return runs into a wall that is out of square, the corner is templated as the angle it really is rather than as ninety degrees. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. The join count is stated with its reason. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Alcove pieces get cut oversize on both scribe edges, with the true wall angles carried on the template drawing rather than assumed. Send photographs of every corner of the room and it gets priced properly first time. Priced as fabrication, not as area. Send the extension drawing or the unit layout with the actual appliance model numbers, since cut-out sizes come from the appliance, not the cabinet. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Written to be read by whoever is paying.