Worktop templating in Lessness Heath

Yes. Lessness Heath is on the patch, and the postcodes we work here are DA17. It is worked on our south east London run, along with the rest of Bexley. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The chimney breast in the corner has usually been left in place, so the run gains a return and two scribed ends. Where the room has been knocked through to the dining room or opened into a later extension, the two floors rarely sit at the same level and the whole opening has to be shot across from one datum. Recorded as it is, not as it was drawn. Standard interwar layouts, but a lot of the rear walls are single-skin later additions, check what you're fixing an upstand to.

Wide suburban roads with verges and drives, easy turning and no permit schemes; the slope down toward Erith is the only awkward stretch. Even an easy kerbside carry wants the pavement clear at the tail lift, because a three-metre piece on edge has a swing radius nobody expects until it is swinging. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Alcove pieces get cut oversize on both scribe edges, with the true wall angles carried on the template drawing rather than assumed. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. All base units in, including anything standing on the later extension slab, walls skimmed to final thickness, and the sink, tap and hob delivered so cut-outs and tap centres are set from the actual items. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.