Worktop templating in Belvedere

Yes. Belvedere is on the patch, and the postcodes we work here are DA17. It is worked on our south east London run, along with the rest of Bexley. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Rear access through a garden or a shared path means long pieces can usually come in whole from the back. Unit height is the other issue: legs sit on an uneven screed or hard concrete with no give, so the template reads the top of every carcass rather than assuming they share a height. Two to three hours, once the units are in. The split between the hill and the flat riverside changes the job entirely, establish which end of Belvedere you're quoting before assuming driveway access.

A hard climb from the riverside up to the higher roads, with plenty of houses set above the pavement behind steps; the lower estates have parking courts and rear access paths. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. That is part of what the visit is for.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The template records every angle in that shape as it actually is rather than as the plan drew it. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. It is recorded on the drawing with the run dimensions so the workshop is not guessing. Measured at worktop height, nowhere else. Every base unit fixed to the wall, packed and levelled, and any dry-lining or patching completed - the template reads the wall face it is given, so that has to be the finished face. Consent for the work sits with the freeholder or the managing body, and getting it in writing first avoids a crew arriving to a locked door. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan.