Worktop fabrication in Belvedere

Yes. Belvedere is on the patch, and the postcodes we work here are DA17. It is worked on our south east London run, along with the rest of Bexley. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Many have been extended at the rear since being sold, so the kitchen is half original and half newer with a floor junction between the two. The notch around a boxed stack is machined with a radius, because a square internal corner there is where a top fails. The bench proves it before the van moves. The split between the hill and the flat riverside changes the job entirely, establish which end of Belvedere you're quoting before assuming driveway access.

A hard climb from the riverside up to the higher roads, with plenty of houses set above the pavement behind steps; the lower estates have parking courts and rear access paths. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. So the nesting is worked to the measured route first and to the slab second. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. The drawing decides it, not the fitter. The stack boxing needs to be in its final form and the sink and hob on site before we machine, since a boxing that gets re-clad afterwards throws the notch out. Consent for the work sits with the freeholder or the managing body, and getting it in writing first avoids a crew arriving to a locked door. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Changes cost a piece, not a tweak.