Worktop installation in Lessness Heath

Yes. Lessness Heath is on the patch, and the postcodes we work here are DA17. It is worked on our south east London run, along with the rest of Bexley. A free-parking street with cars both sides can still leave the van forty metres away, and that distance is carry, not driving. A van that has to move mid-fit costs the best part of an hour and takes a man off the tools to do it. The day is built around that window. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A side alley and a back door mean most pieces go in whole, and it is the alley width rather than the front door that decides it. The fitting itself is slower than the carry: original plaster on the party wall and around the old chimney breast is rarely square to the run, so back scribes get cut on site, and where a return wraps into a breast recess we template that shoulder tight and ease it in. The slow parts are slow for a reason. Standard interwar layouts, but a lot of the rear walls are single-skin later additions, check what you're fixing an upstand to.

Wide suburban roads with verges and drives, easy turning and no permit schemes; the slope down toward Erith is the only awkward stretch. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. We walk the route with a tape and protect it end to end before the first piece is lifted. It gets checked before the first piece is lifted.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The fitting day is scheduled to suit that rather than to suit the diary. One visit, done properly. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. One visit, with the sink and hob seated and sealed before we leave. The prep list is not optional.

Two runs meeting at an internal corner is the most common shape we fit, and the corner is where the decisions are. Joins are pulled with suction clamps and finished flush, then colour-matched, which is the last thing done rather than the first. Nothing is bonded until the whole run sits flat. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. The back edge is eased in progressively rather than offered up once and forced. It is the slow part of the day and it should be. Unlock and clear the side gate and back door, and move bins, planters and washing lines out of the alley run. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Access for the whole slot, or a different day.