Worktop templating in Millbank

Yes. Millbank is on the patch, and the postcodes we work here are SW1P. It is worked on our central London run, along with the rest of Westminster. A red route means no stopping, and no stopping means exactly that, so the stone comes in from a side street or from a bay behind the property. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A riverside block is a managed building with a booked goods lift, a loading bay and a concierge, and all three have to line up on the same day. The template records that corner as it is, so the mitre closes tight instead of being cut to a theoretical 90 degrees. Recorded as it is, not as it was drawn. Closing up a hatch leaves a patched wall that is never flush with the rest - template after the plastering, not before, or the upstand will not sit tight.

Purpose-built blocks with porters, a residents' lift and a separate service lift, and most managing agents restrict works to weekday daytime with no weekend noise. Millbank itself is a red route so vehicles use the block's own forecourt or a booked bay. Piece length is set by the internal diagonal of the lift car, not by the length of the slab. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Housings and integrated appliances are set out for a 38mm laminate top, so dropping to 20mm or 30mm stone changes the clearances and needs checking before anything is cut. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Appliances on site, not on order. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Join positions and vein direction are marked on the template drawing before it leaves site. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. It is recorded on the drawing with the run dimensions so the workshop is not guessing. Measured at worktop height, nowhere else. Boards taped or skimmed and finished, units fixed back to the wall and levelled off, and the appliances on site - the wall must be at its final thickness on template day, so no tiler or splashback fitter gets ahead of the worktop. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.