Kitchen worktops in Munster Village

Yes. A lot of these houses were long ago split into a ground-floor flat with the garden and a first-floor flat with the loft, so you get two small kitchens per address, each around 2.4-3m with a peninsula. The upper flats put the kitchen in a rear addition with a low mono-pitch ceiling, which limits wall-cupboard height and pushes the design toward a longer run and stone upstands. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. Old tops out and new stone in, both through the same gap.

flat-fronted Victorian terrace, two-storey terrace split into upper and lower flats, flat over shop on Munster Road and small modern infill. A two-up two-down has a kitchen that was never designed to be one, so the run is short, the ceiling is low and every millimetre of depth gets argued over. In most Victorian terraces the kitchen sits in the back addition, so you get a narrow galley with one outside wall and nothing square to work off. What is under the old top is the real question.

Flat-fronted terraces open straight onto the pavement with no front garden, so you unload directly at the door but you are standing in the footway while you do it - a short window and a spotter is the way. Upper flats are reached by a stair immediately behind the street door with a turn at the top, which is a hard limit around 2.4-2.6m for a piece carried on edge. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. It sets what the day actually looks like.

Worktop replacement, worktop splashbacks & upstands and worktop installation, in that order. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. One visit, done properly. Two flats in one house means two small jobs and two sets of stairs - price them as separate installs, not one address.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Corners get their own pieces. Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. Rushing that is what leaves a gap you look at every morning for fifteen years. Eased in, never forced. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. The fitting day is arranged with whoever can actually give us access for the whole slot. Access for the whole slot, or a different day. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.