Worktop templating in Munster Village

Yes. Munster Village is on the patch, and the postcodes we work here are SW6. It is worked on our west London run, along with the rest of Hammersmith and Fulham. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cottage terraces have no hall to speak of and the front door opens almost straight into the room, which makes the carry easier and the protection harder. The template plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. Recorded as it is, not as it was drawn. Two flats in one house means two small jobs and two sets of stairs - price them as separate installs, not one address.

Flat-fronted terraces open straight onto the pavement with no front garden, so you unload directly at the door but you are standing in the footway while you do it - a short window and a spotter is the way. Upper flats are reached by a stair immediately behind the street door with a turn at the top, which is a hard limit around 2.4-2.6m for a piece carried on edge. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan.