Worktop fabrication in New Cross

Yes. New Cross is on the patch, and the postcodes we work here are SE14. It is worked on our south east London run, along with the rest of Lewisham. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The flat entrance door and the internal doorways are usually tighter than the communal stairs, which is the opposite of what most people assume. The galley run down a side-return usually measures longer than a slab will give us, so a join is designed in from the start and nested to land over a cabinet gable rather than wherever the material happens to run out. Settled on the drawing, cut once. Landlord and HMO work here wants a hard-wearing, easily replaced run, not a book-matched island.

The main road junctions are heavy with traffic and red-route restrictions, so unloading happens on the side streets, and many terraces have steps up to a raised front door. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. So the nesting is worked to the measured route first and to the slab second. The drawing carries that decision through to the saw.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. A licensed shared house has fire-door and escape-route rules that decide how and when stone can be carried through the common parts. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us. Small kitchens in a shared house are all short runs and tight cut-out spacing, which is more bench work per square metre than one large kitchen would be. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match.

The step or level change between the original room and the return is real, and the units need packing before stone goes across it. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. A let property is specified for durability and for a fixed window, and both of those are legitimate reasons to choose differently. Changing an appliance after the nest is set means recutting the piece, not adjusting it. Changes cost a piece, not a tweak.