Worktop fabrication in New Cross Gate

Yes. New Cross Gate is on the patch, and the postcodes we work here are SE14. It is worked on our south east London run, along with the rest of Lewisham. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. That is the last thing settled before dispatch. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The internal stair is usually a straight flight with a tight top landing, and it is the landing rather than the flight that is the limit. Walls in the system-built blocks are concrete or panel and can bow noticeably over the length of a run, so the template picks up the real line and we cut the back edge to follow it rather than trimming on site with a grinder. Settled on the drawing, cut once. Small lifts and deck walkways make jointed pieces normal, design the joint into the run rather than apologising for it later.

Estate layouts with parking courts, deck access and small lifts, and the retail park and main road restricting where a van can wait; most flats are walk-up or served by a single lift. The lift has to be booked and blanketed before anything moves, and that booking needs to cover the old tops coming out as well as the new stone going in. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. The drawing carries that decision through to the saw.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The stack boxing needs to be in its final form and the sink and hob on site before we machine, since a boxing that gets re-clad afterwards throws the notch out. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. Changing an appliance after the nest is set means recutting the piece, not adjusting it. The approved drawing is the instruction.