Worktop fabrication in Putney Vale

Yes. Putney Vale is on the patch, and the postcodes we work here are SW15. It is worked on our south west London run, along with the rest of Wandsworth. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

There is usually a shared rear alley, and whether the gate onto it is unlocked decides whether long pieces come in from the back. What does drive the bench work is the knocked-through kitchen-diner: the return worktop and any peninsula are seen end-on from the dining side, so we nest the pieces so the veining carries across the internal corner in the same direction rather than turning through ninety degrees. The bench proves it before the van moves. Wall space is short here, so if a client wants a full-height stone splashback behind the hob, check the extractor bracket position first, it usually lands right where the panel edge would be.

The estate sits beside the A3 and is reached from a small number of entrances, so the approach has to be right first time or it means a long detour. Inside the estate the roads are quiet with unrestricted parking close to the doors. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. So the nesting is planned around it rather than around a standard kitchen. Nested for the job in front of us. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Changes cost a piece, not a tweak.