Worktop replacement in Queensbury

Yes. Queensbury is on the patch, and the postcodes we work here are NW9, HA8. It is worked on our north west London run, along with the rest of Brent. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. We stage the strip-out so the old tops leave in one trip rather than trickling out across the afternoon. The waste run is planned, not improvised. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

There is usually a shared rear alley, and whether the gate onto it is unlocked decides whether long pieces come in from the back. The kitchen is normally the original back room with a later side-return or rear extension bolted on, and that helps us: most pieces can go down the side alley and in through the back door in one length, so we can avoid joins that a front-door route would force. What is under the old top is the real question. This is repeat like-for-like territory, so template around retained units and check the old top was not hiding a packed-out, out-of-level base run.

Very wide roads with verges and consistent dropped kerbs, so the van gets onto the drive on most jobs. Flats above the shopping parades are the exception and mean a narrow rear stair with a tight turn. Weight tells on a staircase more than anywhere else, because there is nowhere to set a piece down mid-flight and no way to change your grip once it is moving. We plan the strip-out and the carry as one movement so the kitchen is only out of use for a single day. It sets what the day actually looks like.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop templating and worktop installation. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Old tops out in the morning, new stone down and sealed the same afternoon. A plumber either side of us. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project.

The return piece is the awkward one on a slab: short, full depth, and rarely nesting neatly against the long lengths, so yield rather than area is what moves the material figure. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. The units stay, the surface changes. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. We would rather find it at template than on the morning, which is why the templater looks behind the units. Found at template, not on fit day. Unlock the side gate and clear the alley of bins, bikes and pots, and arrange a plumber for the sink and an electrician if the hob is hard-wired. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Units kept, surface changed.