Worktop installation in Queensbury

Yes. Queensbury is on the patch, and the postcodes we work here are NW9, HA8. It is worked on our north west London run, along with the rest of Brent. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. A van that has to move mid-fit costs the best part of an hour and takes a man off the tools to do it. We would rather ask than guess. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The back door frequently opens straight into the kitchen, which is the best carry route in the house and the one people forget to mention. The carry is the easy part; the plaster around the old breast and the packing over a moved floor are not. The slow parts are slow for a reason. This is repeat like-for-like territory, so template around retained units and check the old top was not hiding a packed-out, out-of-level base run.

Very wide roads with verges and consistent dropped kerbs, so the van gets onto the drive on most jobs. Flats above the shopping parades are the exception and mean a narrow rear stair with a tight turn. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. Finding it out on the morning costs the whole slot, because there is no second route to fall back on. None of it is worked out on the doorstep.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The fitting day is scheduled to suit that rather than to suit the diary. One visit, done properly. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. One visit, with the sink and hob seated and sealed before we leave. Sealed before we leave.

Where the return runs into a wall that is out of square, the corner is templated as the angle it really is rather than as ninety degrees. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. It is the slow part of the day and it should be. Unlock and clear the side gate and back door, and move bins, planters and washing lines out of the alley run. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. Floors and units are protected before anything comes through the door, communal or otherwise. Access for the whole slot, or a different day.