Worktop templating in Richmond Hill

Yes. Richmond Hill is on the patch, and the postcodes we work here are TW10. It is worked on our south west London run, along with the rest of Richmond upon Thames. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Listing and conservation conditions apply to a good number of these, which constrains what can be altered around the kitchen rather than what goes on top of the units. The template plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. No stone is ever cut from a plan. Listed status rules out cutting back a wall to make a run fit, so the top is templated to the building as found, bows and all.

The hill is steep with double yellows on most of the frontage, listed railings that cannot be removed, and a narrow area stair down to the basement door - so slabs go down on edge with a man below and a man above. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. That is part of what the visit is for.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop replacement. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Alcove pieces get cut oversize on both scribe edges, with the true wall angles carried on the template drawing rather than assumed. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan.