Worktop fabrication in Richmond Hill

Yes. Richmond Hill is on the patch, and the postcodes we work here are TW10. It is worked on our south west London run, along with the rest of Richmond upon Thames. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Rooms are tall with deep window reveals, and a run finishing into a reveal is templated to it rather than assumed square. Pieces are sized to the tightest turn on the route before anything is nested to the slab. The bench proves it before the van moves. Listed status rules out cutting back a wall to make a run fit, so the top is templated to the building as found, bows and all.

The hill is steep with double yellows on most of the frontage, listed railings that cannot be removed, and a narrow area stair down to the basement door - so slabs go down on edge with a man below and a man above. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. So the nesting is planned around it rather than around a standard kitchen. Nested for the job in front of us. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.