Splashbacks and upstands in Rotherhithe

Yes. Rotherhithe is on the patch, and the postcodes we work here are SE16. It is worked on our south east London run, along with the rest of Southwark. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A two-up two-down has a kitchen that was never designed to be one, so the run is short, the ceiling is low and every millimetre of depth gets argued over. A 100mm upstand bedded on silicone is the honest answer where the plaster bows, because it rides what a tall panel exposes. Cut from the same slab run as the tops. The listed and near-listed cottages have low ceilings and doorways under 1.9m, so pieces have to be sized to turn through the hall rather than to suit the kitchen alone.

Rotherhithe Street is a long single-carriageway loop with restricted kerbside and gated riverside courtyards, and the Rotherhithe Tunnel has height and width limits that rule out anything larger than a transit coming in from the north side. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. It decides panel size before anything is cut.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Same batch, same run, same day. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Sockets final before template.

A peninsula is an island with one end tied to a run, which means the join between them has to be planned rather than allowed to happen. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Corners get their own pieces. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a run finishes into a reveal, the depth of that reveal is taken at worktop height and nowhere else. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. Make the wall good first, or accept the detail. The chimney breast recess must be replastered and fully dry, and the hob and extractor positions fixed, before anyone templates a full-height piece into it. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. Full-height panels need the wall made good first, which is another trade and another timescale. Decided before fabrication, not after.