Splashbacks and upstands in Shad Thames

Yes. Shad Thames is on the patch, and the postcodes we work here are SE1. It is worked on our south east London run, along with the rest of Southwark. A free-parking street with cars both sides can still leave the van forty metres away, and that distance is carry, not driving. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Poured screed over steel decking can fall away across a long run, so level is checked across the whole room before anything is packed. Exposed brick is the defining issue: the face is uneven by 10mm or more across a bay, so a stone splashback either scribes to it, which means the back of the panel has to be relieved, or it is deliberately set proud on a subframe with a shadow reveal all round. The wall makes that decision, not the brochure. Measure the lift and the stair turn before you cut anything - a slab that fits the kitchen but not the lift is a wasted day here.

The street itself is cobbled and shaded by the overhead gantry bridges with no room to park a van beside the door; lifts are small original goods lifts or tight passenger cars, so oversized pieces have to be planned to fit the car diagonally or go up the stairs on edge. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. Joint positions follow from that.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop fabrication and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Sockets final before template.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Corners get their own pieces. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. Scribed, dubbed out, or set proud. Pick one. Decide and build the backing method, scribe, subframe or board, before the template, because the templater is measuring to that face and not to the brick. Where the owner is not local, the decisions happen remotely, so photographs and a clear itemised drawing carry more weight than a showroom visit ever would. Full-height panels need the wall made good first, which is another trade and another timescale. The wall has to be ready.