Worktop installation in Rotherhithe

Yes. Rotherhithe is on the patch, and the postcodes we work here are SE16. It is worked on our south east London run, along with the rest of Southwark. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. A van that has to move mid-fit costs the best part of an hour and takes a man off the tools to do it. The day is built around that window. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A small room puts the sink, hob and tap cut-outs close together on one short length, and the bridge of stone left between them decides whether it can be cut in one piece. We measure the front door, the hall width and the turn into the kitchen before anything comes off the van, because a 3m piece has to swing through that corner on edge and stone does not bend to help you. Walked, measured, protected, then lifted. The listed and near-listed cottages have low ceilings and doorways under 1.9m, so pieces have to be sized to turn through the hall rather than to suit the kitchen alone.

Rotherhithe Street is a long single-carriageway loop with restricted kerbside and gated riverside courtyards, and the Rotherhithe Tunnel has height and width limits that rule out anything larger than a transit coming in from the north side. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. The prep list is not optional. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The fitting day is scheduled to suit that rather than to suit the diary. Sealed before we leave.

Peninsulas frequently land on a lightweight partition or on units that were never fixed down, and stone needs proper support under it before it goes on. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. The join is the last thing finished. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Clear the full hall and stairs route of furniture, bikes, coats and stair-gates, and keep the front door propped and unobstructed for the carry. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The fitting day is arranged with whoever can actually give us access for the whole slot. Access for the whole slot, or a different day.