Kitchen worktops in Royal Arsenal Riverside

Yes. Apartments with a factory-fitted single-wall kitchen plus island, or a compact galley in the converted historic buildings where thick masonry eats the plan. The usual upgrade is swapping builder's-spec composite for 20mm quartz with a matching upstand, units untouched. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew.

listed Arsenal building conversion, 2000s riverside apartment block and 2010s-2020s tower. The room is genuinely square and the units are plumb, so the visit is more about the building than about the kitchen. New-build rooms are genuinely square, but they are dot-and-dab plasterboard, and the taped internal angle is where it goes wrong - the board bellies at the corner and the run picks up a few millimetres over the last 300mm. Recorded as it is, not as it was drawn.

A gated estate with a barrier, controlled vehicle access and time-limited loading arranged through estate management; the listed conversions add restrictions on what can be fixed into original brickwork. Estate roads are often too tight for a long-wheelbase van to turn, so the carry starts a good deal further from the door than a map suggests. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

Worktop replacement, worktop templating and worktop splashbacks & upstands, in that order. Housings and integrated appliances are set out for a 38mm laminate top, so dropping to 20mm or 30mm stone changes the clearances and needs checking before anything is cut. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Sockets final before template. In the listed blocks you often can't chase or drill historic walls, so upstands and end supports have to be carried by the units alone.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Where a partition has been built off the floor screed rather than off the slab, it moves, and a mitre bonded across that corner is the first thing to open. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. Full-height panels need the wall made good first, which is another trade and another timescale. Decided before fabrication, not after. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.