Worktop installation in Shepherd's Bush

Yes. Shepherd's Bush is on the patch, and the postcodes we work here are W12. It is worked on our west London run, along with the rest of Hammersmith and Fulham. Loading exemptions on red routes are narrow, time-limited and heavily camera-enforced, so we plan around them rather than relying on them. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. The day is built around that window. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The flat entrance door and the internal doorways are usually tighter than the communal stairs, which is the opposite of what most people assume. We measure the front door, the hall width and the turn into the kitchen before anything comes off the van, because a 3m piece has to swing through that corner on edge and stone does not bend to help you. That is the shape of the day. Clear the communal hall of bikes before the slab arrives - on these conversions the obstruction is usually other people's belongings, not the building.

Uxbridge Road and the Green are bus-heavy with loading bans through the day, and the market end has stalls on the carriageway, so unloading is on the terraced side streets. Multiple flats behind one street door means a communal hall full of bikes and bins, and the stairs are typically 850-900mm wide with a half-landing turn. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. Finding it out on the morning costs the whole slot, because there is no second route to fall back on. That is what the morning is planned around.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. One visit, with the sink and hob seated and sealed before we leave. One visit, done properly. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. The fitting day is scheduled to suit that rather than to suit the diary. Sealed before we leave.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Clear the full hall and stairs route of furniture, bikes, coats and stair-gates, and keep the front door propped and unobstructed for the carry. A let property is specified for durability and for a fixed window, and both of those are legitimate reasons to choose differently. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Protection goes down first.