Worktop templating in Somers Town

Yes. Somers Town is on the patch, and the postcodes we work here are NW1. It is worked on our central and north London run, along with the rest of Camden. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Balcony access and long communal corridors are often the carry route, and both are narrower than they look with a piece on edge. Mansion-block kitchens usually have a serviced riser or boxed pipework somewhere in the run, and the boxing is rarely the same depth from one end to the other, so the template takes the depth at worktop height at several points rather than one reading. Recorded as it is, not as it was drawn. Larder and meter recesses in these blocks generate a lot of small returns and cut-outs, so the fabrication list runs longer than the overall run lengths suggest.

Estate courtyards with bollards and controlled gates, narrow internal stairwells, and lifts only in the taller blocks. Euston Road and Pancras Road are red routes, so unloading happens inside the estate or it does not happen at all. The barrier, the entry code and the estate rules decide when a van can get near the door, and none of that is negotiable on the day. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Alcove pieces get cut oversize on both scribe edges, with the true wall angles carried on the template drawing rather than assumed. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Boxing and riser casings built, cased and finished to their final surface, units fixed and levelled, and building access, lift booking and porter arrangements agreed so both the template visit and the later fit can run. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.