Worktop templating in Southfields

Yes. Southfields is on the patch, and the postcodes we work here are SW18, SW19. It is worked on our south west London run, along with the rest of Wandsworth. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The back addition is a narrow two-storey outrigger with a single external wall, and the kitchen galley runs the length of it. Victorian party walls and chimney-breast returns bow along their length, so the template plots the real line rather than assuming a straight one - the template picks up points every few hundred millimetres down the back of the run and the drawing carries that curve through to the saw. No stone is ever cut from a plan. Upper maisonette stairs in this stock rarely take anything over 2.6m, so upper-flat jobs are planned around a joint from the start.

Permit-only parking across the grid and pressure during the tennis fortnight make timing important, and the roads are too narrow for a van to pass a parked lorry. Upper maisonettes have their own front door and a straight stair with a tight 90 degree turn at the top. Weight tells on a staircase more than anywhere else, because there is nowhere to set a piece down mid-flight and no way to change your grip once it is moving. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. That is part of what the visit is for.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop replacement.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.