Worktop templating in Putney

Yes. Putney is on the patch, and the postcodes we work here are SW15. It is worked on our south west London run, along with the rest of Wandsworth. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Permitted works hours are commonly weekdays with a late start and an early finish, so a one-day fit is planned around the porter and the lift. Anything that has to stay accessible - stopcocks, gas meters, riser access panels - is marked on the template so the stone is cut around it instead of over it. Recorded as it is, not as it was drawn. Assume the lift is unusable in the older blocks and plan piece sizes around the stair turn, a 2.4m maximum is a safer starting point than the room dimensions suggest.

The High Street is a red route with a bus gate and no stopping, and the surrounding streets are permit-controlled. Mansion blocks frequently have a small original lift that will not take a slab, meaning a stair carry up two or three flights with a half-landing turn each time. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

Because a peninsula is seen from both sides, the underside of any overhang gets the same edge treatment as the top, which is easy to leave out of a spec. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. That is why the visit takes two or three hours. Boxing and riser casings built, cased and finished to their final surface, units fixed and levelled, and building access, lift booking and porter arrangements agreed so both the template visit and the later fit can run. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.