Splashbacks and upstands in Putney

Yes. Putney is on the patch, and the postcodes we work here are SW15. It is worked on our south west London run, along with the rest of Wandsworth. A red route means no stopping, and no stopping means exactly that, so the stone comes in from a side street or from a bay behind the property. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. That is why they are crated the way they are. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The lift is a small passenger car with a gate, and the alternative is a stone stair winding round the shaft with a turn at every half-landing. Mansion block kitchens are full of boxed-in soil stacks, gas risers and heating pipework, and the boxing is usually plywood or plasterboard that stops short of the ceiling, so the splashback run gets broken up by returns rather than running clean wall to wall. Decided before fabrication starts. Assume the lift is unusable in the older blocks and plan piece sizes around the stair turn, a 2.4m maximum is a safer starting point than the room dimensions suggest.

The High Street is a red route with a bus gate and no stopping, and the surrounding streets are permit-controlled. Mansion blocks frequently have a small original lift that will not take a slab, meaning a stair carry up two or three flights with a half-landing turn each time. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. It decides panel size before anything is cut.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Same batch, same run, same day. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Sockets final before template.

A peninsula is an island with one end tied to a run, which means the join between them has to be planned rather than allowed to happen. Long runs almost never take a single panel, so the joint positions want agreeing before anything is templated. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. The riser boxing must be finished in its final form and any access panel positions agreed before the template, since the stone is set out around them. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. Splashbacks are cut from the same slab run as the tops, so they have to be decided before fabrication, not after. The wall has to be ready.