Worktop templating in Wimbledon Park

Yes. Wimbledon Park is on the patch, and the postcodes we work here are SW19. It is worked on our south west London run, along with the rest of Merton. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The back addition is a narrow two-storey outrigger with a single external wall, and the kitchen galley runs the length of it. Victorian party walls and chimney-breast returns bow along their length, so the template plots the real line rather than assuming a straight one - the template picks up points every few hundred millimetres down the back of the run and the drawing carries that curve through to the saw. Recorded as it is, not as it was drawn. Extension floors here are often laid before the units go in and settle unevenly, so the base cabinets need packing and re-levelling on template day or the joint on a long run opens up.

Permit-holder bays fill up from mid-morning and the streets are narrow enough that a parked van blocks a lane. Upper conversion flats are reached by a straight but tight internal stair with a half-landing turn, so long lengths have to be measured against the stairwell diagonal before ordering. Weight tells on a staircase more than anywhere else, because there is nowhere to set a piece down mid-flight and no way to change your grip once it is moving. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. That is part of what the visit is for.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop replacement. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Window boards and cills stand proud of the plaster, so the back edge of the top has to be plotted to where the units actually sit rather than to the wall. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan.