Kitchen worktops in Southfields

Yes. The grid of Edwardian terraces has consistent plans with a rear addition that owners widen and lengthen, ending up with a kitchen of roughly 3.4m by 5m holding a long run and a modest island. Many houses are split into upper and lower maisonettes, and the upper one gets a compact L in the old rear bedroom. A controlled parking zone means either a visitor permit sorted in advance or a suspended bay, and a suspension is applied for days ahead rather than on the morning. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. The waste run is planned, not improvised.

Edwardian terrace, Edwardian semi and Interwar mansion flat. The addition wall is half a brick thick in places and has usually had a damp course injected and been re-plastered, which leaves it neither flat nor consistent. In most Victorian terraces the kitchen sits in the back addition, so you get a narrow galley with one outside wall and nothing square to work off. Units kept, surface changed, one day.

Permit-only parking across the grid and pressure during the tennis fortnight make timing important, and the roads are too narrow for a van to pass a parked lorry. Upper maisonettes have their own front door and a straight stair with a tight 90 degree turn at the top. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. The template records it along with everything else.

Worktop templating, worktop installation and worktop replacement, in that order. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. Upper maisonette stairs in this stock rarely take anything over 2.6m, so upper-flat jobs are planned around a joint from the start.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Plotted, not estimated. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Sound carcasses are the condition. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.