Worktop replacement in St Mary Cray

Yes. St Mary Cray is on the patch, and the postcodes we work here are BR5. It is worked on our south east London run, along with the rest of Bromley. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Deck access means a long open walkway from the lift or the stair to the front door, and that walk happens with the piece on edge in whatever weather there is. The plaster is bonded straight onto the concrete, so the bottom course of tiles tends to bring plaster with it when the old top comes off, leaving a rough band behind the upstand. Units kept, surface changed, one day. For maisonette stairwells we cut to fit and bring the pieces up on edge, because you cannot swing a full length round a half-landing.

Estate roads with parking bays and grass verges you cannot drive over, plus first-floor maisonettes reached by external stairs and a shared landing. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. The strip-out is planned around it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop splashbacks & upstands and worktop templating. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. Carcasses have to be sound first. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. This is the commonest reason a replacement turns out to need more than a straight swap. The laminate has been covering it up. Sort a parking bay or permit near the entrance, confirm the lift is in service and get us the door codes, and tell us about any asbestos survey on the flat before we start stripping out. A let property is specified for durability and for a fixed window, and both of those are legitimate reasons to choose differently. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Units kept, surface changed.