Worktop fabrication in St Mary Cray

Yes. St Mary Cray is on the patch, and the postcodes we work here are BR5. It is worked on our south east London run, along with the rest of Bromley. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. That is the last thing settled before dispatch. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Deck access means a long open walkway from the lift or the stair to the front door, and that walk happens with the piece on edge in whatever weather there is. The notch around a boxed stack is machined with a radius, because a square internal corner there is where a top fails. Settled on the drawing, cut once. For maisonette stairwells we cut to fit and bring the pieces up on edge, because you cannot swing a full length round a half-landing.

Estate roads with parking bays and grass verges you cannot drive over, plus first-floor maisonettes reached by external stairs and a shared landing. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. Once the cut-outs are machined there is no going back on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. So the nesting is planned around it rather than around a standard kitchen. Proven on the bench before dispatch.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. The drawing decides it, not the fitter. The stack boxing needs to be in its final form and the sink and hob on site before we machine, since a boxing that gets re-clad afterwards throws the notch out. Where the owner is not local, the decisions happen remotely, so photographs and a clear itemised drawing carry more weight than a showroom visit ever would. Changing an appliance after the nest is set means recutting the piece, not adjusting it. The approved drawing is the instruction.