Worktop replacement in Surrey Quays

Yes. Surrey Quays is on the patch, and the postcodes we work here are SE16. It is worked on our south east London run, along with the rest of Southwark. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. The waste run is planned, not improvised. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Infill plots usually put the kitchen at the back with wide doors to a small garden, and that opening is the best route in. Housings set out for a 38mm laminate change clearance when you drop to 20mm or 30mm stone, and that is checked before cutting. Sound carcasses are the one condition. These kitchens were built to a budget with 600mm carcasses that have sagged, so the units usually need packing and levelling before a stone top goes anywhere near them.

Estate roads loop and dead-end around the water, so satnav puts you on the wrong side of a dock; most houses have an allocated bay or an integral garage forecourt within carrying distance of the door. Estate roads are often too tight for a long-wheelbase van to turn, so the carry starts a good deal further from the door than a map suggests. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. That is agreed before a plumber is booked.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop splashbacks & upstands. Housings and integrated appliances are set out for a 38mm laminate top, so dropping to 20mm or 30mm stone changes the clearances and needs checking before anything is cut. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. Carcasses have to be sound first. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A lightweight stud partition will not carry a breakfast bar or a peninsula end, and stone finds that out faster than laminate ever did. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. Found at template, not on fit day. Book the service lift, loading bay and concierge access for the full day, and confirm the building's permitted working hours in writing. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed.