Worktop replacement in Peckham

Yes. Peckham is on the patch, and the postcodes we work here are SE15. It is worked on our south east London run, along with the rest of Southwark. A controlled parking zone means either a visitor permit sorted in advance or a suspended bay, and a suspension is applied for days ahead rather than on the morning. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. In most Victorian terraces the kitchen sits in the back addition, so you get a narrow galley with one outside wall and nothing square to work off. Units kept, surface changed, one day. Half these jobs land mid-build with the extension still drying out, so template late and check the plaster is on before you cut.

Tight terraced streets with permit bays, a lot of skips and builders' vans competing for kerb, and rear access rarely usable because gardens back onto other gardens rather than a lane. Rear access usually lets us fit longer pieces whole, so the join count ends up decided by the slab rather than by the building. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. The strip-out is planned around it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop design & quotation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Where a single building holds several small kitchens, the work arrives as one job rather than four, and it should be cut off the same slab run so the batches genuinely match. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. Small kitchens in a shared house are all short runs and tight cut-out spacing, which is more bench work per square metre than one large kitchen would be. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The existing layout is being kept, so the question is whether the old carcasses will take stone in that shape without more support. Carcasses have to be sound first. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. This is the commonest reason a replacement turns out to need more than a straight swap. It is the usual surprise, and it is a known one. Have a plumber booked to disconnect the sink, tap and waste first thing and reconnect after we have gone, and clear the hallway and stairs completely so we can carry slabs through the house. Consent for the work sits with the freeholder or the managing body, and getting it in writing first avoids a crew arriving to a locked door. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed.