Worktop templating in Peckham

Yes. Peckham is on the patch, and the postcodes we work here are SE15. It is worked on our south east London run, along with the rest of Southwark. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The flat entrance door and the internal doorways are usually tighter than the communal stairs, which is the opposite of what most people assume. Victorian party walls and chimney-breast returns bow along their length, so the template plots the real line rather than assuming a straight one - the template picks up points every few hundred millimetres down the back of the run and the drawing carries that curve through to the saw. Recorded as it is, not as it was drawn. Half these jobs land mid-build with the extension still drying out, so template late and check the plaster is on before you cut.

Tight terraced streets with permit bays, a lot of skips and builders' vans competing for kerb, and rear access rarely usable because gardens back onto other gardens rather than a lane. Rear access usually lets us fit longer pieces whole, so the join count ends up decided by the slab rather than by the building. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. The template records it along with everything else.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop design & quotation. Batching several kitchens together is the one situation where buying a whole slab is cheaper per kitchen rather than more expensive. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn. Where a single building holds several small kitchens, the work arrives as one job rather than four, and it should be cut off the same slab run so the batches genuinely match. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan.