Worktop design and quotation in Temple Fortune

Yes. Temple Fortune is on the patch, and the postcodes we work here are NW11. It is run from the Watford side, covering Hertfordshire & North London. Bay bookings are usually an hour or two, which is fine for unloading and no use at all as a place to leave the van for a day. Tell us at enquiry stage and it is priced properly, because a crew stood waiting is the most expensive thing on any job. You are told before you commit to a date. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A side alley and a back door mean most pieces go in whole, and it is the alley width rather than the front door that decides it. These are typically two runs and a return, often into a rear extension, and the return piece is the awkward one — short, wide and rarely nesting well against the long pieces on the slab, so slab yield rather than total area is what pushes the material line up. You see it before you commit to anything. Sloping ceilings over part of the run mean the slab cannot be tilted upright at that end, so it has to enter the room already close to horizontal.

Flats over the parades are reached by narrow shared stairs from the rear yards, with no lift and a turn at each landing; Finchley Road frontage has loading restrictions and constant bus traffic. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. You see that figure before we template, not after. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Itemised, so it can be compared honestly.

Because a peninsula is seen from both sides, the underside of any overhang gets the same edge treatment as the top, which is easy to leave out of a spec. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. No installed rate per square metre, because it is not a real number. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Better on the quote than in a variation. Send the extension drawing or the unit layout with the actual appliance model numbers, since cut-out sizes come from the appliance, not the cabinet. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. Material is quoted as a supply range and the labour lines separately, because an installed rate per square metre is not a real number. Nothing payable until template.