Worktop design and quotation in Upper Norwood

Yes. Upper Norwood is on the patch, and the postcodes we work here are SE19. It is run from the New Malden side, covering South West London & Surrey. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. It sits in the fitting line as time on site rather than as anything to do with the stone. You are told before you commit to a date. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A large villa has wide doors, a generous hall and somewhere to park, so the joins that go in are chosen for layout rather than forced by the route. If the island top is a few hundred millimetres longer than the usable length of a slab, you buy a second slab to gain that overhang — the whole slab, not the part you use — and that is a material decision worth more than any other line on the quote. Priced from the building, not from a rate card. Low ceilings in lower ground floor kitchens mean you cannot tilt a long piece to get it round a corner, so anything over 2.4m gets a designed joint before it leaves the shop.

The steepest streets in the borough, with houses set well above or below road level and long flights of front steps. Lower ground floor kitchens mean carrying stone down as well as along. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. We price the carry from what you tell us about the route, so photographs of the approach are worth more to us than a floor plan. Nothing about it gets estimated after the fact. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop fabrication and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Itemised, so it can be compared honestly. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. The join count is stated with its reason. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. Send photographs of every corner of the room and it gets priced properly first time. Better on the quote than in a variation. Send the island size including the overhang and which side people sit at, the stool count, and confirm the edge profile you want and which edges are to receive it. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Material is quoted as a supply range and the labour lines separately, because an installed rate per square metre is not a real number. Written to be read by whoever is paying.