Worktop templating in Wandsworth Common

Yes. Wandsworth Common is on the patch, and the postcodes we work here are SW18, SW11, SW12. It is worked on our south west London run, along with the rest of Wandsworth. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Rooms are tall with deep window reveals, and a run finishing into a reveal is templated to it rather than assumed square. Alcoves either side of the breast are rarely the same width and rarely parallel, so each one is templated as its own piece with its own scribe. Recorded as it is, not as it was drawn. Getting stone down a lightwell stair is the constraint here, not the room, measure the stair headroom and the turn radius before agreeing any single-piece island top.

Many of these houses have a lower-ground entrance via a front lightwell with a steep flight of steps and a tight turn at the bottom, the worst carry in the area. On-street parking is permit-controlled with limited visitor bays. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. The template records it along with everything else.

It is one of the three we do most here, behind worktop design & quotation. Same template visit, same workshop, same installers either way. Extended households run kitchens hard, and that pushes the specification towards granite or sintered stone rather than a light quartz. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn. Households sharing a house tend to want two prep areas rather than one, which usually means an island as well as a perimeter run. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Appliances on site, not on order.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. The template records every angle in that shape as it actually is rather than as the plan drew it. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.