Worktop templating in Clapham Junction

Yes. Clapham Junction is on the patch, and the postcodes we work here are SW11. It is worked on our south west London run, along with the rest of Wandsworth. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A flat over a shop is reached by a separate street door and a straight steep stair, and that stair is the whole access question. Post-war terraces have a fairly shallow, standardised kitchen, and the walls tend to lean rather than bow, so the scribe at worktop height is different from the one at plinth level - the template only cares about the line where the stone will land. No stone is ever cut from a plan. For the above-shop flats plan on two shorter pieces with a deliberate joint at the sink rather than one long top, because the stair simply will not take the length.

This is one of the worst spots in the borough for standing a van, bus lanes, red route sections, and constant traffic around the station. Above-shop access is by a shared street door and a long steep stair with a landing turn at the top. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. That is part of what the visit is for.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop fabrication. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Units fixed, packed level and pushed as far back as the leaning wall allows, walls made good to final thickness with tiling left until after the worktop, and the sink, tap and hob on site so cut-outs are set from the real items. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.