Worktop fabrication in Wandsworth Town

Yes. Wandsworth Town is on the patch, and the postcodes we work here are SW18. It is worked on our south west London run, along with the rest of Wandsworth. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A riverside block is a managed building with a booked goods lift, a loading bay and a concierge, and all three have to line up on the same day. Piece size is set by the lift car, not by the slab. The bench proves it before the van moves. In open-plan riverside flats the peninsula end is seen from three sides, so a mitred waterfall with matched veining is usually specified and the joint quality is judged at eye level.

The gyratory and the retail traffic make timing critical, and the riverside blocks require booked loading bays with a hard time limit plus a lift with a stated capacity. Terraced streets off the main roads are permit-controlled all week. The lift has to be booked and blanketed before anything moves, and that booking needs to cover the old tops coming out as well as the new stone going in. So the nesting is worked to the measured route first and to the slab second. Once the cut-outs are machined there is no going back on it.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. So the nesting is planned around it rather than around a standard kitchen. Proven on the bench before dispatch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us.

Peninsulas frequently land on a lightweight partition or on units that were never fixed down, and stone needs proper support under it before it goes on. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a partition has been built off the floor screed rather than off the slab, it moves, and a mitre bonded across that corner is the first thing to open. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. Machined to the real line. Sink, tap and hob need to be with us before machining, along with confirmation of whether the island is getting a breakfast overhang, since anything past roughly 300mm unsupported needs steel let into the carcasses and that has to be built in, not added later. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves.