Worktop fabrication in Latchmere

Yes. Latchmere is on the patch, and the postcodes we work here are SW11. It is worked on our south west London run, along with the rest of Wandsworth. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A small room puts the sink, hob and tap cut-outs close together on one short length, and the bridge of stone left between them decides whether it can be cut in one piece. Pieces are sized to the tightest turn on the route before anything is nested to the slab. The bench proves it before the van moves. In these blocks the waste position is fixed and often high in the wall, so the sink cutout cannot be moved more than a few centimetres without re-plumbing.

Estate blocks have controlled entry and shared stairs; the older ones have balcony access along the front, which means a long horizontal carry past neighbours' doors. Parking bays on the estate are permit-allocated and enforced. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. So the nesting is worked to the measured route first and to the slab second. Once the cut-outs are machined there is no going back on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Consent for the work sits with the freeholder or the managing body, and getting it in writing first avoids a crew arriving to a locked door. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. Dry-assembled before it leaves.