Worktop fabrication in Battersea

Yes. Battersea is on the patch, and the postcodes we work here are SW11, SW8. It is worked on our south west London run, along with the rest of Wandsworth. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cottage terraces have no hall to speak of and the front door opens almost straight into the room, which makes the carry easier and the protection harder. The galley run down a side-return usually measures longer than a slab will give us, so a join is designed in from the start and nested to land over a cabinet gable rather than wherever the material happens to run out. The bench proves it before the van moves. Cottage kitchens here run out of headroom before they run out of width, so check the height under the stair bulkhead where the run passes beneath it.

Cottage streets are narrow, fully permit-controlled and parked solid, with front doors opening straight onto a 1.2m pavement. Ceilings are low and the hall is short, so a slab cannot be swung, it goes in flat and low. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. So the nesting is worked to the measured route first and to the slab second. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.