Kitchen worktops in Battersea

Yes. The artisan cottage streets have very shallow plans where the kitchen fills the whole ground-floor rear, so a single 3m run with a slim return is the realistic maximum. Larger Victorian terraces towards the park take a rear infill with a compact island of around 2m. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap.

Victorian artisan cottage, Late Victorian terrace, Edwardian mansion flat and 2010s riverside apartment. A small room puts the sink, hob and tap cut-outs close together on one short length, and the bridge of stone left between them decides whether it can be cut in one piece. In most Victorian terraces the kitchen sits in the back addition, so you get a narrow galley with one outside wall and nothing square to work off. What is under the old top is the real question.

Cottage streets are narrow, fully permit-controlled and parked solid, with front doors opening straight onto a 1.2m pavement. Ceilings are low and the hall is short, so a slab cannot be swung, it goes in flat and low. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. It sets what the day actually looks like.

Worktop replacement, worktop installation and worktop templating, in that order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. Cottage kitchens here run out of headroom before they run out of width, so check the height under the stair bulkhead where the run passes beneath it.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Eased in, never forced. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.