Worktop installation in Latchmere

Yes. Latchmere is on the patch, and the postcodes we work here are SW11. It is worked on our south west London run, along with the rest of Wandsworth. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. A van that has to move mid-fit costs the best part of an hour and takes a man off the tools to do it. The day is built around that window. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A two-up two-down has a kitchen that was never designed to be one, so the run is short, the ceiling is low and every millimetre of depth gets argued over. We measure the front door, the hall width and the turn into the kitchen before anything comes off the van, because a 3m piece has to swing through that corner on edge and stone does not bend to help you. The slow parts are slow for a reason. In these blocks the waste position is fixed and often high in the wall, so the sink cutout cannot be moved more than a few centimetres without re-plumbing.

Estate blocks have controlled entry and shared stairs; the older ones have balcony access along the front, which means a long horizontal carry past neighbours' doors. Parking bays on the estate are permit-allocated and enforced. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. We walk the route with a tape and protect it end to end before the first piece is lifted. It gets checked before the first piece is lifted.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. One visit, done properly. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The fitting day is scheduled to suit that rather than to suit the diary. The prep list is not optional.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Eased in, never forced. Clear the full hall and stairs route of furniture, bikes, coats and stair-gates, and keep the front door propped and unobstructed for the carry. Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. Floors and units are protected before anything comes through the door, communal or otherwise. Access for the whole slot, or a different day.