Kitchen worktops in Wood Street

Yes. A mix of un-extended terraces with 2.4m galley kitchens and larger Edwardian houses that have gone full-width at the rear with a 4m run and an island. The newer flats near the station have single-wall kitchens against a party wall with no island space. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew.

Victorian terrace, Edwardian bay-fronted house and recent station-area apartment block. Lease conditions and the other flats in the building decide when noisy work can happen, so the fitting day has a start and a finish that are not ours to set. The day is planned backwards from the hall. Walked, measured, protected, then lifted.

The railway splits the area, so streets on either side need approaching separately and the bridge and level crossing points create bottlenecks at peak times. Residential streets are permit-controlled with narrow bays, and terraces have no side access, so the route is front door, hall, through room, kitchen. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. The fitting day is planned backwards from that point, before anything comes off the van. It gets checked before the first piece is lifted.

Worktop templating, worktop installation and worktop replacement, in that order. Small kitchens in a shared house are all short runs and tight cut-out spacing, which is more bench work per square metre than one large kitchen would be. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. The through-room route means every piece has to clear a pair of internal door openings, and 900mm island slabs frequently will not turn at the second one.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.