Worktop installation in Wood Street

Yes. Wood Street is on the patch, and the postcodes we work here are E17. It is worked on our east London run, along with the rest of Waltham Forest. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. We measure the front door, the hall width and the turn into the kitchen before anything comes off the van, because a 3m piece has to swing through that corner on edge and stone does not bend to help you. That is the shape of the day. The through-room route means every piece has to clear a pair of internal door openings, and 900mm island slabs frequently will not turn at the second one.

The railway splits the area, so streets on either side need approaching separately and the bridge and level crossing points create bottlenecks at peak times. Residential streets are permit-controlled with narrow bays, and terraces have no side access, so the route is front door, hall, through room, kitchen. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. The fitting day is planned backwards from that point, before anything comes off the van. It gets checked before the first piece is lifted.

It is one of the three we do most here, behind worktop templating. Same template visit, same workshop, same installers either way. A licensed shared house has fire-door and escape-route rules that decide how and when stone can be carried through the common parts. One visit, with the sink and hob seated and sealed before we leave. The prep list is not optional. Where a single building holds several small kitchens, the work arrives as one job rather than four, and it should be cut off the same slab run so the batches genuinely match. The fitting day is scheduled to suit that rather than to suit the diary. Sealed before we leave.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. Joins are pulled with suction clamps and finished flush, then colour-matched, which is the last thing done rather than the first. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. Rushing that is what leaves a gap you look at every morning for fifteen years. It is the slow part of the day and it should be. Clear the full hall and stairs route of furniture, bikes, coats and stair-gates, and keep the front door propped and unobstructed for the carry. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Protection goes down first.