Worktop templating in Angel

Yes. Angel is on the patch, and the postcodes we work here are N1, EC1. It is run from the Watford side, covering Hertfordshire & North London. A red route means no stopping, and no stopping means exactly that, so the stone comes in from a side street or from a bay behind the property. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Georgian houses put the kitchen in a basement or a rear closet wing, and the stairs down to it are the tightest part of the whole route. Victorian party walls and chimney-breast returns bow along their length, so the template plots the real line rather than assuming a straight one - the laser picks up points every few hundred millimetres down the back of the run and the drawing carries that curve through to the saw. Recorded as it is, not as it was drawn. Check the filtered-street layout before fit day, because a wrong turn through a camera gate costs more than the delivery and the legal approach usually adds a long carry.

Upper Street is a red route with bus lanes, City Road and Pentonville Road are red routes on the southern edge, and the side streets are controlled Monday to Friday with some seven-day bays near the Green. Several surrounding streets sit inside camera-enforced traffic filters, so the route in for a van is not the route a satnav gives you. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. That is why the visit takes two or three hours. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The template happens when the units are in, fixed and level, whoever is fitting them. Appliances on site, not on order.