Worktop templating in Pentonville

Yes. Pentonville is on the patch, and the postcodes we work here are N1. It is run from the Watford side, covering Hertfordshire & North London. Loading exemptions on red routes are narrow, time-limited and heavily camera-enforced, so we plan around them rather than relying on them. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Lease conditions and the other flats in the building decide when noisy work can happen, so the fitting day has a start and a finish that are not ours to set. Victorian party walls and chimney-breast returns bow along their length, so the template plots the real line rather than assuming a straight one - the laser picks up points every few hundred millimetres down the back of the run and the drawing carries that curve through to the saw. Two to three hours, once the units are in. Chimney recesses give you a 300-400mm deeper pocket in an otherwise standard run, which is worth using for a wider top rather than boxing out to a false wall.

Pentonville Road is a red route sitting on the Congestion Charge boundary with almost no stopping on the hill, and the side streets are permit-only and one-way. Front doors step with the gradient, so every house on a terrace is a different height off the pavement. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. The laser records it along with everything else. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Batching several kitchens together is the one situation where buying a whole slab is cheaper per kitchen rather than more expensive. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order. Batching several kitchens together is the one situation where buying a whole slab is cheaper per kitchen rather than more expensive. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. It is recorded on the drawing with the run dimensions so the workshop is not guessing. That is why the visit takes two or three hours. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.